E-Light IPL RF Pigments / Red Face Removal Hair Removal Machines , 1000W

E Light IPL RF Skin Rejuvenation Hair Removal Slimming

IPL Skin Rejuvenation Hair Removal Freckle Removal Slimming Pigments Removal Slimming Beauty Machine

 

Brief Introduction

E-light applies three core technology, IPL, RF, and epidermis cooling. It combines the advantage of IPL and RF, in one hand, the skin absorbs IPL energy selectively, and the skin also absorbs RF energy, on the other hand, the RF-surface-touch cooling technology removing the discomfort and complications by high heat of IPL. Therefore, the effect and safety of E-light makes a breakthrough.
 

1. Principle
Applying the technique of IPL and Bi-polar Radio Frequency, the equipment acts on the entire skin corium and connective tissue, stimulates the collagens of different depth to realign and grow, then gets treatment effect. Bio-polar RF release energy at the same time, with the selective absorption for the skin to light energy, various pathological tissues of corium and epidermis creates Photothermolysis effect. Since light energy is far below conventional IPL, the pigment tissue and vascular pathological tissue of the corium and epidermis would absorb more energy without injuring the epidermis, and then remove these pathological tissues better and get the effect.

2. Application:
1. Hair removal (including dark skin);
2. Skin rejuvenation
3. Acne treatment;
4. Removing freckle, age spots, sun spots, pigmentation troubles, etc;
5. Removing red face, red capillary, and bottle nose


 

Technique Specification

IPL Power: 1000W
RF Intense Electric Energy: 5MHz
Light Energy: 15-50J/cm2
Pulse Amount: 1-6
Pulse Width: 1-10 ms
Pulse Delay: 1-100 ms
Repeat frequency: 1-4s
RF working time: 50-2500 ms
Spot size: 8x40mm
Filters: 530nm, 560nm, 640nm ( 2 pcs), 690nm
N.W.: 50kg
Voltage: 230V±10%, 50~60Hz

 

Accessory List

Main frame 1set
E-light Handpiece 2pc
RF Handpiece 1pc
Filters 5x2 pc
Power Lead 1pc
Key Switch 2pc
Goggles for Operator 1pair
Goggles for Patient 1pair
Spare Plugs & fuses 2pc
Water funnel 1pc

 

Operation Instruction

Connect the handle and filters:
1. Put the E-light handle on the hanger
2. Connect the E-light handle to the connecting port on the back board of the machine tightly.
3 Check the water holes of the backboard, make sure the water outlet hole is plugged well.
 

Water infusing:
1 pull out the plug of the water inlet hole,insert the water funnel
2 infuse water till water spill out from the spillway hole.
 

Checking
1 Make sure there is no water leaking;
.2 Make sure there is no moisture or wet for electricity connecting parts;
3 Make sure the key switch is in the off position;
4 Make sure the emergency stop switch is in the on position.
 

Starting the equipment
1 Connect the power cord, turn on the key switch;
.2 Double confirm there is no leaking of water circulation, fold the protective cover by turning it right.
 

Debugging
1. Make sure water and electric circuit is correct connected; then turn on the power to start the machine.
2. Turn on the master power switch on the backboard;
3.Turn on the emergency switch (clockwise turn) in the front side of the mainframe